haier HWM88-0566T - Manual (Page 7)

5 12
b
The drainage shall be smooth with the drain hose.
1. The height of the drain hose shall be less than 10cm,
or the drainage will not be smooth, and cost such long
time that the machine may stop at mid way.
2. Do not step on or press the drain hose.
4. If extra drain hose is needed, please make separate
purchase. The inner diameter of the extra hose shall
not less than 30mm, and the length shall not exceed
1.5m.
3. If the drain hose is too long, cut it at mid point. To make
smooth drainage, cut the front end of the hose slantingly.
Usage the drain hose
5.If the extra hose is too long, cut it either at A or at B.
How to change the direction of the drain hose Steps of using the operation buttons and description
of the steps
Remarks: in order to make sure of the correct of installation, it is suggested to change the direction of the drain hose
with our company serviceman .
Drain hose support
Drain hose
Drain bushing Drain bushing
Drain outlet
protecting cover
Drain bushing
Drain hose fixing
clamp
Cabinet
Inner Outer
Push
Push
Take down
Figure 1 Figure 2
Figure 3
Figure 4 Figure 5
Figure 6
2.Put down the drain hose Take off the drain hose
frame as indicated in Figure 1.Take the drain hose into
the cabinet ,then nip the drain fixing clamp to make it
deviated from the clip
the other hand is used to put
down the drain bushing,as indicated in Figure 2,3.
1.Dismantle the rear cover of the washing machine. 3.Dismantle the drain outlet protecting cover at the other side,
(the way is the same as the drain bushing),then install the drain
bushing, as indicated in Figure 4.
4.Extend the drain hose from the other side. Fix the drain hose
with drain hose frame onto the cabinet, as indicated in Figure 5.
5.Install the drain outlet protecting cover to the other side,
as indicated in Figure 6
PO WER
ON /OFF
PROGRAM
STA RT
PAU SE
AIR DRY
BLANKET
SAVE
SILK
STANDARD COTTON
1HOUR
2HOURS
RESERVE
PROCESS
WATER LEVE L
SOAK
WASH
RINSE
SPIN
1
2
3
4
RESERVE(HOURS LATER)
TIME REMAINED(MINUTES)
4
5 2 3 6
7
1.Push "power" button to switch on the power
2.Push "program" button to select suitable
full-auto program
After the power is switched on, "standard" is automatically set. To select other full-auto program, please
push the "program" button till the corresponding indicator is on. Refer to the "Program button" on Page 11.
E.g. Set to "SAVE"program for small quantity of laundries with light soil.
Attention
Even there's no water in the tub, a certain period is required before spin starting.
Separate the laundries that are not colorfast from other laundries in washing.
The soak procedure can work in cooperation with automatic programs like standard, blanket
cotton. There is intermittent pulsator stirring during soak.
After the machine starts operation, you can only set the program and procedure during washing,
and can not make setting in other cases.
3 Push "Process" button to select suitable procedure program
POWER
ON/OFF
PROGRAM
PROCESS