Harbor Freight Tools 96500 - Manual (Page 13)

Page 13 SKU 96500 for technical questions, please call 1-800-444-3353.
Replace Spark Plug by hand for the first few turns, then tighten securely with the socket
wrench. A Spark Plug with a new Gasket requires 1/2 more turn to tighten than the
used Gasket which requires 1/8 to 1/4 turns to tighten.
changing Oil
Run the Engine for five minutes to warm up the oil, then shut off the Engine.
Place a drain pan under the Drain Plug.
Remove the Dip Stick and unscrew the Drain Plug.
Allow all the oil to drain out into the pan. Pour the used oil into a container with a lid.
Deliver used oil to a recycling center. Do not dump oil into the earth or storm drain.
Dispose of oil in a manner approved by state, local, and federal regulations.
Replace Drain Plug and securely tighten.
Add 1/2 quart of 10W30 motor oil through a funnel (not included) into the Dip Stick fill
hole. Fill until the oil reaches the Upper Level line of the fill hole.
Replace the Dip Stick carefully.
cleaning the deposit cup
Push the Fuel Valve to the closed (left) position.
Using a wrench (not supplied), loosen and remove the Bolt
under the Deposit Cup. Place a pan below the Deposit
Cup to catch any remaining gasoline.
Remove the Deposit Cup and O-ring, and wash them in
cleaning solvent.
Reinstall the Deposit Cup and O-ring.
Push the Fuel Valve to the open (right) position and check
for gas leaks from the Deposit Cup. Reinstall the Deposit Cup and tighten hardware.
4.
1.
2.
3.
4.
5.
6.
7.
1.
2.
3.
4.
5.