Humax VA-3210 - Manual (Page 7)

6
To the digital receiver, you can connect either a single satellite antenna directly or through converter
box several antennas or LNB of multi-feed equipment.
You can connect a further Sat-receiver (for example analog), with the receiver of common
antenna equipment that has satellite signals.
If you have another analogue or digital STB and you wish to use the same LNB then you can connect
it via the loop through. Connect one end of a Coaxial cable to the LNB OUT on the STB and connect
the other end to the LNB IN on your second STB.
HUMAX digital set-top box is a highly sophisticated product - incorporating one of the best software
applications. Whenever a problem is found with this software or, in fact, extra functions or enhanced
applications are added, the software in the equipment has to be upgraded.
In order to maintain proper performance of the product, it is essential to have the most up to date
software. The latest news and release of software versions may be found at
HUMAX website - http://www.humaxdigital.com.
It is recommended that users register to HCSA (HUMAX Customer Service Area) and periodically
check for the availability of software upgrade.
There are three methods to upgrade the software:
(a) set-top box to set-top box download (copies the software of the main unit into slave unit);
(b) pc to set-top box download (downloads the software directly from pc to the model requiring upgrade);
(c) OTA over-the-air (downloads the software where the manufacturer reserves the right to
decide when and where to release through satellite system).
Over The Air (OTA) is simply another alternative for downloading software versions.
However, the manufacturer reserves the right to decide when and where this software upgrade can take
place by "beaming" latest software versions over the air via satellite systems. Note that OTA is only
limited to certain geographical regions mainly due to different satellites having different footprints (area
where the signal can be received).
SUSS (TM) is an official trademark and logo for HUMAX loader software to perform OTA.
The software upgrade via satellite system will only occur under the following circumstances:
1) the equipment should have appropriate loader software;
2) the manufacturer decides to release software downloading via a designated satellite system;
3) the equipment must be "tuned" properly to the same satellite that the manufacturer uses.
3. Software Upgrade
Reference
1. Connect a Satellite antenna
2. Loop Through