14. threading welding wire – Hobart Welding Products IRONMAN OM-198 683C User Manual
Page 19
OM-198 683 Page 15
2-14. Threading Welding Wire
1
Wire Spool
2
Welding Wire
3
Inlet Wire Guide
4
Pressure Adjustment Knob
5
Drive Roll
6
Outlet Wire Guide
7
Gun Conduit Cable
Lay gun cable out straight.
4
7
3
5
6
2
1
Tools Needed:
6 in
(150 mm)
.
Hold wire tightly to keep it
from unraveling.
WOOD
Open pressure assembly.
Pull and hold wire; cut off end.
Push wire thru guides into gun;
continue to hold wire.
Close and tighten pressure
assembly, and let go of wire.
Remove gun nozzle and contact tip.
Turn On.
Press gun trigger until wire
comes out of gun. Reinstall
contact tip and nozzle
Feed wire to check drive roll pressure.
Tighten knob enough to prevent slipping.
Cut off wire. Close
and latch door.
Ref. 802 064-A / S-0627-A
Tighten
1
2
3
4
.
Use pressure indicator
scale to set a desired
drive roll pressure.
Pressure
Indicator
Scale
Tighten
1
2
3
4