Five Star JHP - Manual (Page 4)

Page 4
Section 1. Important Safety Instructions
READ AND FOLLOW ALL INSTRUCTIONS
1.1 Safety Instructions
All electrical work must be performed by a licensed electrician and conform to all national, state, and local
codes.
When installing and using this electrical equipment, basic safety precautions should always be followed,
including the following:
WARNING
To reduce the risk of injury, do not permit children to use this product.
WARNING
RISK OF SUCTION ENTRAPMENT HAZARD, WHICH, IF NOT AVOIDED CAN RESULT IN SERIOUS
INJURY OR DEATH. Do not block pump suction as this can cause severe injury or death. Do not use this
pump for wading or shallow pools or spas containing bottom drains, unless the pump is connected to at
least two functioning suction outlets. Drain covers must be certified to ANSI/ASME A112.19.8.
WARNING
To reduce the risk of property damage or injury, do not attempt to change the backwash (multiport, slide,
or full flow) valve position with the pump running.
WARNING
The Jandy ® Pumps are powered by a high voltage electric motor and must be installed by a licensed or
certified electrician or a qualified swimming pool service tech ni cian.
WARNING
Due to the potential risk of fire, electric shock, or injuries to persons, Jandy ® Pumps must be installed in
accordance with the National Electric Code, all local electrical and safety codes, and the Occupational
Safety and Health Act (OSHA). Copies of the National Electrical Code may be ordered from the National Fire
Protection Association, 470 Atlantic Ave., Boston, MA 02210, or contact your local government inspection
agency.
WARNING
Incorrectly installed equipment may fail, causing severe injury or property damage.
WARNING
• Do not connect system to an unregulated city water system or other external source of pressurized water
producing pressures greater than 35 PSI.
• Trapped air in system can cause the filter lid to be blown off which can result in death, serious personal
injury, or property damage. Be sure all air is out of system before operating.