Quick configuration guide, Registering your fortinet product, Factory default settings – Fortinet 5003A User Manual

Page 21

Advertising
background image

Quick Configuration Guide

Registering your Fortinet product

FortiSwitch-5003A System Guide
01-30000-77803-20080917

21

Quick Configuration Guide

This section is a quick start guide to connecting and configuring a
FortiSwitch-5003A board.

Before using this chapter, your FortiGate-5000 series or compatible ATCA chassis
should be mounted and connected to your power system. In addition, your
FortiSwitch-5003A board should be inserted into the chassis. The
FortiSwitch-5003A board should also be powered up and the front panel LEDs
should indicate that the boards are functioning normally.

This chapter includes the following topics:

Registering your Fortinet product

Factory default settings

Basic configuration

Upgrading FortiSwitch-5003A firmware

Additional configuration

Registering your Fortinet product

Register your Fortinet product to receive Fortinet customer services such as
product updates and technical support. You must also register your product for
FortiGuard services such as FortiGuard Antivirus and Intrusion Prevention
updates and for FortiGuard Web Filtering and AntiSpam.

Register your product by visiting

http://support.fortinet.com

and selecting Product

Registration.

To register, enter your contact information and the serial numbers of the Fortinet
products that you or your organization have purchased. You can register multiple
Fortinet products in a single session without re-entering your contact information.

Factory default settings

The FortiSwitch-5003A unit ships with a factory default configuration. The default
configuration allows you to connect to and use the FortiSwitch-5003A CLI to
configure the FortiSwitch-5003A board. To configure the FortiSwitch-5003A board
you add an administrator password, change the management interface IP
address, and, if required, configure the default route for the management
interface.

Table 7: FortiSwitch-5003A factory default settings

Administrator Account

User Name: admin
Password: (none)

MGMT IP/Netmask

192.168.1.99/24

Default route

Gateway: 192.168.1.254
Device: mgmt

Advertising