Frymaster HD1814 SERIES HD21814G - Manual (Page 15)

FRYMASTER HD1814 SERIES GAS FRYERS
CHAPTER 3: INSTALLATION
3-1
3.1 Installing the Fryer
There are no built-in leveling devices on fryers equipped with casters. The floor where the fryer is
to be installed must be level.
DANGER
Fryers must be at room temperature and empty of oil during movement to avoid
damage and possible bodily injury.
DANGER
Hot oil can cause severe burns. Avoid contact. Under all circumstances, oil must be
removed from the fryer before attempting to move it to avoid oil spills, and the falls
and severe burns that could occur. This fryer may tip and cause personal injury if
not secured in a stationary position.
3.2 Gas Connections
DANGER
Before connecting new pipe to this appliance the pipe must be blown out thoroughly
to remove all foreign material. Foreign material in the burner and gas controls will
cause improper and dangerous operation.
NATIONAL CODE REQUIREMENTS
This equipment is to be installed in compliance with the Basic Plumbing Code of the Building
Officials and Code Administrators International, Inc. (BOCA) and the Food Service Sanitation
Manual of the U.S. Food and Drug Administration.
This equipment is manufactured to use the type of gas specified on the rating plate attached to the
door. Connect equipment stamped "NAT" only to natural gas and that stamped "PRO" only to LP
(Propane) gas.
Notice
Installation shall be made with a gas connector that complies with national and local
codes. Quick disconnect devices, if used, shall likewise comply with national and
local codes.
DANGER
The fryer
MUST be connected to the gas supply specified on the rating and serial
number plate located on the back of the fryer door.