FELLOWES NEPTUNE 125 - Manual (Page 7)

Switch off the machine at the wall. Allow the machine to cool.
The outside of the machine can be cleaned with a damp cloth. Do not use solvents or flammable materials to polish the machine.
Cleaning sheets can be used with the machine. When the machine is warm – run the sheets through the machine to clean any residue
off the rollers.
For optimum performance, it is recommended that cleaning sheets (Fellowes #5320603 are used with the machine regularly.
Problem Possible cause Solution
No ‘red’ power on LED Machine is not switched on
Switch on machine at rear next to plug
inlet and at the wall socket
Ready light does not come on after a
long period
Machine is in a hot or humid area
Move the machine to a cooler and
dry area
Pouch does not completely seal the item
Item may be too thick to laminate Pass through the machine again
Temperature setting may be incorrect
Check pouch thickness is correctly
selected and pass through again
Pouch has waves or bubbles Temperature setting may be incorrect
Check pouch thickness is correctly
selected and pass through again
Pouch is lost in the machine Pouch is jammed
Select reverse button and pull out the
item by hand
Jamming
Pouch was used ‘open end’ first
Pouch was not centered on entry
Pouch was not straight upon entry
Empty pouch was used
Pouch is damaged after lamination Damaged rollers or adhesive on rollers
Pass cleaning sheet (Fellowes
#5320603) through the machine to
test and clean rollers
STORAGE & CLEANING
TROUBLESHOOTING
7
403843_2_NA_Neptune_EFS_v6.2.indd 7 12/08/2009 16:21:21