Fluke 9933 - Manual (Page 62)

Section 3.6 , Table Temperature Range Chart. If the selected minimum and
maximum temperatures are too extreme, the algorithms used to calculate the ta-
ble values may not produce correct results. TableWare has been throughly
tested over the recommended temperature ranges and found to produce correct
results.
6.2 Table Ware Error Messages
Message “An error occurred while calculating coefficient type table values at
temperature. The algorithms used may not be able to solve for this value.
Changing the minimum or maximum temperature for the table may solve this
problem.
[Error: error number - description]"
Remarks The minimum and/or maximum temperatures selected may exceed
the recommended minimum or maximum temperatures for generating the table.
The algorithms used to generate table values cannot always solve for extreme
values. For recommended temperature ranges for generating tables, see Section
3.6 , Table Temperature Range Chart.
Message “There was an error writing to the .INI file:
File: filename
Section: section
Entry: entry
Value: value
[Error: error number – description]”
Remarks TableWare was not able to write to the .INI file. The error num-
ber-description message gives an indication of the reason for this error
message.
Message “All of the required data for coefficient type coefficients has not been
entered.
Reasons:
Reason 1
Reason 2
.
.
.
Reason n
Remarks The raw data entered by the user is not complete. Make sure all of
the required data has been entered according to the reasons listed.
9933 TableWare
User’s Guide
58