Assembly – Fisher-Price JEEP WRANGLAR 74020 User Manual

Page 15

Advertising
background image

Sport Bar

KC

TM

Light Rack -

Front Half

• Position the sport bar with the ends on a flat surface,

as shown.

• Fit and hold the front and back halves of the KC

TM

light

rack against the sport bar. Make sure the two KC

TM

light

rack halves are aligned, and that the screw holes in the
KC

TM

light rack are aligned with the screw holes in the

sport bar.

• Snap the tabs on the front half of the KC

TM

light rack into

the slots below the light housings on the rear half of the
KC

TM

light rack.

• Insert two #6 x1

1

/

2

" screws through the holes in the back

of the KC

TM

light rack, through the sport bar, and into the

front half of the KC

TM

light rack.

• Tighten the screws with a Phillips screwdriver. Do not

over-tighten.

KC

TM

Light Rack - Back Half

Tabs

23

Assembly

• Align the four tabs on the inside of a light cover

with the four slots in one of the light housings on the
KC

TM

light rack. (Make sure the light covers are

positioned with the wide spaced tabs at the top.)

• Push firmly on the light cover to snap it to the housing.

• Repeat this procedure on the other side of the

KC

TM

light rack to assemble the other light.

Light Covers

Housing

Slots

24

21

• Using safety scissors, remove the sport bar brackets

from the plastic connector. Dispose of the plastic
connector.

• Position the sport bar upright.
• Position a sport bar bracket above one of the sport bar

side legs, as shown.

• Insert the tab on the inside of a sport bar bracket into the

hole in the sport bar side leg.

• Fit the ring on a sport bar support against the end of the

sport bar bracket.

• Fold the sport bar bracket over the sport bar to close it

around the sport bar and sport bar support.

Sport Bar

Sport Bar Bracket

Sport Bar Support

Tab

Hole

Side Leg

Ring

22

• Insert a #6 x 1

1

/

2

" screw into the sport bar bracket

as shown.

• Tighten the screw with a Phillips screwdriver. Do not

over-tighten.

• Repeat steps 20 and 21 to attach the other sport bar

support to the other sport bar side leg.

Sport Bar Bracket

Sport Bar

Sport Bar Support

15

Advertising