Fisher-Price FREE SPIRIT TRIKEE 72639 - Manual (Page 5)

5
Assembly
• Turn the frame upright.
• Insert the fork post up through the hole in the neck of
the frame. Make sure the fork is positioned so that
the fork covers face the rear wheels.
• Place the handlebar over the fork post and push it
down onto the frame. Make sure the handlebar is
positioned so that the screw hole faces the rear
wheels and aligns with the screw hole in the fork post.
Hint: You may need to rotate the handlebar to align
the holes.
• Insert the #8 x 3" screw through the hole in the han-
dlebar and into the fork post. Tighten the screw with
a Phillips screwdriver. Do not over-tighten.
Handlebar
Frame Neck
Fork Post
Fork Cover
• Place the front wheel assembly between the fork arms
so that the pedal axle fits into the groove at the bottom
of each fork arm.
• Place a fork cover over the pedal axle on one fork arm.
• Insert two #8 x
3 /
4
" screws into the fork cover and
tighten with a Phillips screwdriver. Do not over-tighten.
• Repeat this procedure to attach the other fork cover
to the other fork arm.
Fork Arms
Pedal Axle
Groove
Fork Cover
#8 x 3 /
4
" Screw – 4
SHOWN ACTUAL SIZE
#8 x 3" Screw – 1
SHOWN ACTUAL SIZE
• At an angle, insert one peg on the back of the seat into
the hole in the rear of the frame.
• Insert and " snap" the other peg on the back of the
seat into the other hole in the rear of the frame.
One-time assembly is now complete.
Seat
Holes
Front Wheel Assembly Pegs 11
12
13
72639c-0920 9/28/01 1:41 PM Page 5