Fisher-Price NICK JR DORA THE EXPLORER J5242 - Manual (Page 4)

4
Assembly
• Fit a pedal on the pedal axle. Tap the pedal with a hammer
until it is secure.
• Pull the pedal up to be sure it is secure. If you can remove
it, you have not secured it properly. Tap it with the
hammer again.
• Repeat this procedure to attach the other pedal to the other
end of the pedal axle.
Pedal Axle
Scrap Block of Wood
Pedal
Pedal Hub
Pedal Hub
• Turn the front wheel
assembly over.
• Insert the remaining pedal
hubs on top of and below the pedal axle and into the hole
in the center of the front wheel.
• Push the pedal hubs into the center of the front wheel until
they are flush with the surface of the front wheel.
6
7
• Place the front wheel assembly between the fork arms.
Make sure the pedal axle fits into the groove at the bottom
of each fork arm.
• Place a fork cover over the pedal axle on one fork arm.
• Insert two #8 x
3 /
4
" screws into the fork cover and tighten.
• Repeat this procedure to attach the other fork cover to the
other fork arm.
Fork Arms
Pedal Axle
Groove
Fork Cover
8
• While holding the pedal hubs
on the pedal axle, insert the
pedal axle through the hole in the center of the front wheel.
• Push the pedal hubs into the center of the front wheel until
they are flush with the surface of the front wheel.
Hole
Pedal Axle
Pedal Hubs
Front Wheel
5