3 adding and deleting network bridges with sac, 1 adding a new sac network bridge, Adding and deleting network bridges with sac – Fortress Technologies ecure Wireless Access Bridge User Manual
Page 121: Adding a new sac network bridge
Fortress Bridge: Command-Line Interface
111
SeriallNum|IpAddress|CfgID|PeerNum|PeerSACStatus|PeerSACState|PeerSACVer
24773196|172.24.0.4|19082|2|SAC_PEER_CONFIRMED|
SAC_COMPLETE_4PEER
|SAC_VER_PEGASUS_ARCH1
24743196|172.24.0.3|19082|1|SAC_PEER_CONFIRMED|
SAC_COMPLETE_4PEER
|SAC_VER_PEGASUS_ARCH1
To save the new configuration, enter
set sac stop
:
[GW]>
set sac stop
SAC Stop Initiated. May take some time to complete...
Stopped SAC process successfully
Reboot_Of_Master(SrlNum:24656196)_Required_For_NewConfiguration(CfgId:42550)_To_Take_Into_Effect
Reboot_Of_SACPeer(SrlNum:24773196)_Required_For_Configuration_Change_From(OldCfgId:19082)_To(New
CfgId:42550)_To_Take_Into_Effect
Reboot_Of_SACPeer(SrlNum:24743196)_Required_For_Configuration_Change_From(OldCfgId:19082)_To(New
CfgId:42550)_To_Take_Into_Effect
As the output informs you, you must reboot the Bridges in the
network for the new configuration to take effect.
SAC commands are valid only in Gateway mode (refer to
Section 6.1.1 for more detail).
6.8.3
Adding and Deleting Network Bridges with SAC
6.8.3.1
Adding a New SAC Network Bridge
Once a network has been configured through SAC, you can
use the SAC function to add a new Fortress Bridge to the
network.
1
Position the new Bridge so that it operates only within its
safe temperature range (14º–122º F/
–
10º–50º C).
2
Connect an 802.11a-capable antenna to antenna port 2
(
ANT2
) of the new Bridge.
3
Connect the
WAN
port of the new Bridge to the
WAN
port of
any node in the SAC network.
4
Connect the new Bridge’s external +48V DC power supply
to its front-panel
+48V DC
power inlet, and plug the power
supply into a properly rated AC power outlet with the cord
provided.
NOTE:
An RJ-45-
to-DB9 adapter—
included with each
Bridge—is required to
connect the Bridge’s se-
rial
Console
port to a
DB9 terminal connec-
tion. Pin outs for these
adapters are given in
Table 7.1 on page 116.
5
Connect the new Bridge’s
Console
port directly to the serial
terminal of the computer you will use to preconfigure the
new Bridge.
6
Open a terminal application on the computer connected to
the new Bridge’s
Console
port and (using the settings given
in Section 6.1.2) open a session with the new Bridge.
7
Log in to the CLI of the new Bridge, using
sysadm
as both
the login ID and password.
8
Preconfigure the new Bridge to use the same Access ID
and encryption algorithm already in effect on the Fortress
Bridge network with these commands:
[GW]>
set accessid <16digithexid>
[GW]>
set crypto [-e aes128|aes192|aes256][-t <hrs>]
9
Use
show sac
to determine—and then make a note of—the
serial number of the new Bridge: