FRIGIDAIRE 316135917 User Manual

Page 8

Advertising
background image

8

Oven Control Style 2 -

Setting the Clock and

Minute Timer

Control Style 2

To Set the Clock Style 2

When the range is first plugged in, or when the power supply to the range has

been interrupted, the display will flash "12:00".

1. Push

.

2. Within 5 seconds, push and hold

or

until the correct time of day

appears in the display.

Note: The clock cannot be changed during any timed bake or self-clean

cycle.

To Set the Minute Timer Clock Style 2

1. Push

.

2. Push

to increase the time in one minute increments. Push and

hold

to increase the time in 10 minute increments. The timer can be

set for any amount of time from 1 minute to 11 hours and 59 minutes.

Note: If you push

first, the timer will advance to 11 hours and 59

minutes.

3. The display shows the timer count down in minutes until one minute

remains. Then the display will count down in seconds.

4. When the set time has run out, the timer will beep 3 times. It will then

continue to beep 3 times every 60 seconds until

is pushed.

Note: The minute timer does not start or stop cooking. It serves as an extra

timer in the kitchen that will beep when the set time has run out. The minute

timer can be used alone or during any of the other oven functions. When the

minute timer is in use with any other mode, the minute timer will be shown in

the display. To view other functions, push the function pad for that mode.

To Change the Minute Timer while it is in use:

While the timer is active and shows in the display, push and hold

or

to increase or decrease the time.

To Cancel the Minute Timer before the set time has run out:

Push

.

For a silent control panel

(Control Style 2 Only):

When choosing a function, a beep

will be heard each time a pad is

pushed. If desired, the controls can

be programmed for silent operation.

Push and hold STOP TIME for 7

seconds. After 7 seconds, the control

will beep once. This will block the

controls from sounding when a pad

is pushed. To return the sound, push

and hold STOP TIME again for 7

seconds until 1 beep is heard. Note:

The control will return to the audible

mode after a power outage.

Advertising