Fortinet 548B User Manual

Page 932

Advertising
background image

- 932 -

Selection Criteria

Slot/Port - Select the slot and port for which data is to be displayed or configured from the pulldown
menu. Slot 0 is the base unit. You must have configured at least one router interface before
configuring or displaying data for an IGMP interface, otherwise an error message will be displayed.

Configurable Data

Interface Mode - Select enable or disable from the pulldown menu to set the administrative status of
IGMP on the selected interface. The default is disable.

Version - Enter the version of IGMP you want to configure on the selected interface. Valid values
are 1 to 3 and the default value is 3. This field is configurable only when IGMP interface mode is
enabled.

Robustness - Enter the robustness value. This variable allows tuning for the expected packet loss
on a subnet. If you expect the subnet to be lossy, you should enter a higher number for this
parameter. IGMP is robust to (robustness variable-1) packet losses. Valid values are from 1 to 255.
The default value is 2.

Query Interval - Enter the frequency in seconds at which IGMP host-query packets are to be
transmitted on this interface. Valid values are from 1 to 3600. The default value is 125.

Query Max Response Time - Enter the maximum query response time to be advertised in IGMPv2
queries on this interface, in tenths of a second. The default value is 100. Valid values are from (0 to
255) .

Startup Query Interval - Enter the number of seconds between the transmission of startup queries
on the selected interface. The valid values are from 1 to 300. The default value is 31.

Startup Query Count - Enter the number of queries to be sent on startup. The valid values are from
1 to 20. The default value is 2.

Last Member Query Interval - Enter the last member query interval in tenths of a second. This the
maximum response time to be inserted into group-specific queries sent in response to leave group
messages, and is also the amount of time between group-specific query messages. Valid values are
from 0 to 255. The default value is 10. This value is not used for IGMP version 1.

Last Member Query Count - Enter the number of queries to be sent on receiving a leave group
report. Valid values are from 1 to 20. The default value is 2.

Command Buttons

Submit - Send the updated configuration to the router. Configuration changes take effect
immediately. These changes will not be retained across a power cycle unless a save is performed.

Advertising