Meridian Audio 808.2 - Manual (Page 35)

31
Configuring the CD
player
Setting up sources
This section explains how to use Gain mode to set up
the analogue sources connected to the CD player.
To turn on Gain mode
Put the CD player into standby by pressing Off (front
panel or remote).
Press and hold the Volume V key under the front
panel for at least five
seconds.
The display shows: Gain On
The CD player will then return to standby with Gain
mode turned on.
Gain mode adds an extra Sensitivity option to the
menus.
To turn off Gain mode
Repeat the above procedure.
The display shows: Gain Off
To adjust the sensitivity of a source
To obtain the best signal-to-noise ratio for your
analogue sources you can adjust the sensitivity of each
input to give the highest level that does not produce
clipping.
Turn on Gain mode, as described above.
Select the source you want to adjust, with loud
source material playing.
Press < or > (remote) until the display shows the
current sensitivity.
For example: Radio 2.0V In
Press A or V (remote) to change the sensitivity.
•
•
•
•
•
•
•
You can select between sensitivities of 0.5V (most
sensitive), 1.0V, 2.0V, or 2.5V (least sensitive).
If the sensitivity is set too high the input will clip the
loudest passages. The display shows:
For example: Radio 0.5V In Clip
In this case reduce the sensitivity.
If you have selected a digital source you cannot adjust
the sensitivity. The display shows:
For example: CD Not Analogue