FORD 2004 - Manual (Page 94)

Press and release the control to
open window to the vent position.
Press and release the control
again to open window to the full
open position.
Press and release the control to
close the window all the way to the
full closed position.
Normal Operation
When the power down back window is opened, it will stop in the vent
position. When the window is closed from full open, it will not stop in
the vent position. When the power down back window is in motion, the
control switch can be pressed to change the window direction and move
it to the closest position.
If the power down back window is moving up and the ignition is
switched to OFF (without accessory delay power enabled) the window
will reverse direction and move down to either the full open or vent
position. If the window is within 0.16 in. (4 mm) of the upper header, it
will completely close.
Bounce-Back
When the back window is moving upward and an obstacle interferes with
the window’s movement, the back window will reverse direction and
move toward the fully open position. This is known as “bounce-back”.
Security Override
If, during a bounce-back condition and within 2 seconds after the
window stops, the control is held in the
direction, the back window
will travel up with no bounce-back protection. If the control is
released before the window reaches fully closed, the back window will
continue moving up with bounce-back re-enabled.
The following are possible reasons for using the security override:
• Ice on the window causing a restriction.
• Window unexpectedly reverses.
Position recovery mode
If the motor loses position and stops mid travel, the motor will respond
to switch inputs by moving 0.6 in. (15 mm) each switch command in the
2007 07+ Explorer Sport Trac (esp)
Owners Guide (post-2002-fmt)
USA (fus)
Driver Controls
94