Frymaster FE155 - Manual (Page 12)

CHAPTER 1: Overview/Component Replacement
1-7
1.8 Replacing a Float Switch
NOTE: The high-level float switch (106-8007) is normally closed. The low-level float switch (106-
9389) is normally open. A kit, 826-2622, contains one float switch that can be used for either posi-
tion by flipping the float, which changes its condition.
1. Drain the cookpot and disconnect the cooker from the electrical
power supply.
2. Remove the baskets, basket rack.
3. Remove the nut securing the float switch.
4. Remove the connecting pins from the harness and lift the float
from its position.
5. Route the wires of the replacement float switch through the cabi-
net and connect them. Remove the float from the float switch kit,
if necessary. Ensure it is positioned properly for the high-level
position (normally closed) or for the low-level position (normally
open).
6. Secure the new float switch, using thread sealer to prevent leaks.
7. Reposition the rethermalizer and allow it to fill to test the float switch operation.
High-level float switch