Fagor America SFA-8CELX - Manual (Page 11)

EN
20
EN 8 / AFTER-SALES SERVICE
Fig. 22
21
Fig. 23
Any work on your appliance must be perfor-
med by a brand approved qualified professio-
nal. When you call, mention your appliance’s
full reference (model, type, serial number).
These details are shown on the manufacturer’s
information plate
(Fig. 22).
ORIGINAL PARTS
During any maintenance work, ask that only
c
ce errttiiffiie ed d o orriig giin na all rre ep plla ac ce em me en ntt p pa arrtts s b be e u us se ed d.
• • INTERVENTIONS
• CHANGING THE BULB
You can replace the light bulb (type E14-
15W/230V) yourself
(Fig. 23).
Important :
Unplug the power cord before chan-
ging the bulb.
To do this :
— Unscrew the glass cover located to the left
inside the appliance.
— Unscrew the extinguished bulb and replace it.
— Screw on the glass cover tightly.
Important :
The bulb must be replaced when the
appliance is cooled down.
7 / TROUBLESHOOTING
Advice :
Some incidents may arise when you are using your dryer. Here are the points you should
check.
Fault : Check whether :
The dryer does not start : - The plug is in the socket
- The On/Off button is pressed in
- The door is properly closed
- The condenser is correctly locked in place.
The drying times are too long : - The filter in the drum is clogged with fluff
- The laundry has been spun enough beforehand
(500rpm minimum, but spinning at 850rpm provides
better drying times)
- The condenser is not clogged.
- The air inlets and outlets are unobstructed enough to
ensure correct air circulation.
- The drying program selected matches the type of
items in the drum.
The laundry is too damp : - The filter in the drum is clogged with fluff
- The type of drying has been selected correctly (too
low) : switch to the next programme up or increase
the drying time.
- The condenser is not blocked by fluff.
The laundry is too dry, too creased : - The drying time selected is too long : the drying time
is better to be too short than too long: this avoids the
laundry becoming too dry and difficult to iron.
The items are unevenly dried : - The types of textiles in the load are too different (e.g.
sheets together with jeans)
- The laundry has been laid correctly ‘unfolded’ in the
dryer
- The drum is not overloaded.
The synthetic items are loaded with
static electricity : - The laundry has been dried too much
- You have used softener during washing. By using this
product, you can reduce most of the problems with
static electricity.
The “Tank Full” indicator light is lit : - The condensate container is full : once you have emp-
tied it, re-insert it correctly, pushing it completely into
its housing
The “Tank Full” indicator light illumina-
tes although the tank is empty : - Check whether the container has been properly inser-
ted: push it in completely.
- Check if the condenser is tightly locked on the two
sides.