Setting surface controls, Caution, Important – FRIGIDAIRE 316902202 User Manual

Page 14

Advertising
background image

14

Fig. 1 (single)

Fig. 2 (dual)

Fig.3 (triple)

Triple radiant surface element (some models)

Depending on your model, the cooktop may have a triple

radiant element. Indicator lights located on the backguard

show which portions of the triple radiant element are set to
heat. The symbol indicates only the inner coil will heat
and should be used for smaller cookware (Fig. 1). The

symbol indicates both inner and middle coils will heat and
may be used for medium to large cookware (Fig. 2). The

indicates that all 3 coils will heat together and should be

used for larger cookware (Fig. 3).

A glowing red surface heating area extending beyond the

bottom edge of the cookware indicates the cookware is too

small for the surface heating area.

Start most cooking operations on a higher setting and then

set to a lower setting to finish cooking. See the Suggested

power level settings table (provided in the instructions

for the single radiant elements).

1. Place correctly sized cookware on

the dual radiant surface element.

2. Press and hold the on-off

for the desired element position

until a beep is heard.

3. Press the desired element size

(once for inner, twice for dual,

3 times for triple).

4. Press lo, med (5.0) or hi.

Each touch of the lo or hi pad will

decrease or increase the power

level by 1/2 from 9.5 through 3.0.

Simmer power levels between

3.0 and 1.2 will decrease or increase

by .2 increments. lo is the lowest

power level available.

5. Once cooking has

completed, press on-off.

Step

Press

To operate the triple radiant surface element:

,

,

SETTING SURFACE CONTROLS

on cooktop

indicator light

indicator light

indicator light

You may switch element size settings at any time while

cooking.

The size and type of utensil used, and the amount and

type of food being cooked will influence the setting

needed for best cooking results.

NOTES

Radiant surface elements may appear to have cooled

after they have been turned off. The glass surface may

still be hot and burns may occur if the glass surface is

touched before it has cooled sufficiently.

Do not place flammable items such as plastic salt and

pepper shakers, spoon holders or plastic wrappings on

top of the range when it is in use. These items could melt

or ignite. Potholders, towels or wooden spoons could

catch fire if placed too close to the surface elements.

CAUTION

The HE (hot element) message will appear in the display

windows once a heating element is turned OFF and will

remain ON until the heating surface area or areas have

cooled sufficiently.

Do not allow aluminum foil, or ANY material that

can melt to make contact with the ceramic glass

cooktop. If these items melt on the cooktop they will

damage the ceramic cooktop.

IMPORTANT

on cooktop

on cooktop

Advertising