FRIGIDAIRE 318201616 - Manual (Page 3)

3
30" ELECTRIC SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
To avoid breakage: Do NOT handle or
manipulate the unit by the cooktop glass.
The counter-top around the cut-out should be flat and
leveled (see hatched area on illustration 1).
The metal flange under each side of the cooktop MUST be
placed over the cabinet countertop for proper unit support.
The glass cooktop should NOT directly touch the countertop
(see illustration 2) or could cause glass breakage voiding the
warranty. Level the unit if needed.
1
Before installing the unit, measure the heights of the two (2)
cabinet sides (H1-4), front and back (see illustration 1) from the
floor to the top of the counter.
H1
H2
H3
H4
Illustration 1
Shave
Raised
Edge
to Clear
Space for a
31½" (81 cm)
Wide
Cooktop.
1 ½" Max.
(3.8 cm Max.)
Remove the protective channels on each side of the glass cook-
top (if provided).
Slide the unit into the cabinet. Make sure the center of the unit is
aligned with the center of the cabinet cut-out.
Illustration 2
To successfully install
the range, the initial
level height from
floor to underside
o f c o o k t o p g l a s s
frame should be at
least 1/16" taller
than cabinet sides as
measured in step 1.
Level the range using the
four (4) leveling legs so
that the height from the
floor to the underside of
the cooktop glass frame
is greater than the tallest
cabinet measurement
by at least 1/16" (see
illustration 2).
After the installation, MAKE SURE that the unit
is supported by the leveling legs NOT by the
cooktop.
Glass
Frame
2
3
4
5
6
7