Fluke 807-0115 - Manual (Page 3)

Technical Data
T1/E1 i nline probe ASE
W i t h L i n k S a f e c a p a b i l i t i e s
Key features
Inband management capabilities
LinkSafe technology
Power loss detection
Multi-Protocol or IP Transport software
Service Level Agreement (SLA) metrics
Voice over IP (VoIP) analysis capability
Application analysis capability
LMI spoofi ng
LAN management port
Realtime events
•
•
•
•
•
•
•
•
•
•
The Visual UpTime® Select™ T1/E1 LinkSafe™ inline
probe ASE is deployed inline on a T1 or E1 access line,
typically between a service provider’s edge device and
CSU/DSU. This ASE supports Multi-Protocol software
for deployment in standard frame relay or HDLC
networks and IP Transport software for deployment
in frame relay or HDLC-based networks that use IP
switching. The ASE also includes LinkSafe technology
to protect circuit integrity in case of an ASE outage,
as well as power failure notifi cation.
When confi gured for use on an E1 network, the ASE
complies with the physical/electrical characteristics
defi ned by ITU-T G.703 at 2.048 Megabits per second
(Mbps). The ASE also complies with the synchronous
frame structure specifi cations defi ned by ITU-T G.704,
including the option to use channel 16 for data or
signalling. You can either connect to the E1 network
using a 120 ohm balanced cable or BNC coax 75 ohm
unbalanced cables.
T1/E1 inline probe model model 807-0113 rear view
T1/E1 inline probe model 807-0113 front view
T1/E1 inline probe model 807-0113 position on network
Visual UpTime Select
ASE model 807-0113
T1/E1 Access Line
LAN
T1/E1 inline ASE
Optional LAN Connection
CPE Router
Visual UpTime
Select Server
WAN
CSU/DSU