Freedom9 2420 - Manual (Page 20)

freeConnect Smart 2420 User’s Manual
17
Figure 15: Port Setting Page
After clicking on a port number, the screen below (Figure 16) will open, allowing you to set the
Speed/Disable, Flow Control and QoS settings of the port.
Figure 16: Port Configuration
Speed/Disable:
This setting has six modes: 100M Full, 100M Half, 10M Full, 10M Half, Auto, Disable. The first four
allow you to manually set the speed and duplex, Auto sets the port to detect the connection type
automatically, and Disable shuts down the port.
Flow Control:
This setting determines whether or not the Switch will handle flow control. Select Enable to avoid data
transfer overflows. Select Disable to turn off flow control.
When the port is set to full duplex mode, the flow control will automatically be set to Disable. If the
port is set to half duplex mode, the flow control will automatically be set to Enable.