FRIGIDAIRE 318200710 - Manual (Page 9)

9
Ceramic Glass Cooktop (some models) (continued)
EXPANDABLE RADIANT HEATING UNITS (some models)
This heating unit adapts to both small and large heating utensils. The unit control
dial has a dual set of graduations. For small utensils use the left side of the control
dial; for large utensils the right. Only the inner surface of the unit heats when using
it for small utensils; the whole surface heats for large utensils. The hot surface and
surface indicator lights will glow when the heating unit is turned ON.
Note: During any heat setting of the outer radiant element, the inner radiant ele-
ment cycles on and off with the outer element.
BRIDGE RADIANT HEATING UNITS (some models)
Its principal advantage is to allow you to create larger cooking zone for larger pan
suchs as roaster, griddle or some other specialty pans.
To use the bridge element, turn the control knob on right side, to the bridge burner
graduations.
For full bridge element operation turn on the left rear burner.
To use only the front element, turn the control knob on left side, to the front burner
graduations.
Two different surface control lights will glow on your range: Surface Indicator
Lights and Hot Surface Indicator Lights.
• The surface indicator lights, located on the control panel, glow when any
surface unit is turned on. A quick glance at the lights after cooking is an easy
check to be sure all surface controls are turned off.
• The hot surface indicators lights, located under the glass cooktop, will
come on as the surface cooking area heats up and will continue to glow until
the glass cooktop has cooled down to a moderate level. The lights may remain
on even though the controls are turned to OFF.
Setting Surface Controls
(continued)
Indicator Lights
(for models with Ceramic
Glass Cooktop)
Expandable & Bridge Radiant
Element Control Dial
Knob may look different