FUJITSU MPD3XXXAT - Manual (Page 58)

C141-E069-02EN 4 - 13
4.6.3 Read circuit
The head read signal from the PreAMP is regulated by the automatic gain control (AGC)
circuit. Then the output is converted into the sampled read data pulse by the programmable
filter circuit and the adaptive equalizer circuit. This clock signal is converted into the NRZ
data by the 16/17 GCR decoder circuit based on the read data maximum-likelihood-detected
by the Viterbi detection circuit, then is sent to the HDC.
(1) AGC circuit
The AGC circuit automatically regulates the output amplitude to a constant value even when
the input amplitude level fluctuates. The AGC amplifier output is maintained at a constant
level even when the head output fluctuates due to the head characteristics or outer/inner head
positions.
(2) Programmable filter
The programmable filter circuit has a low-pass filter function that eliminates unnecessary high
frequency noise component and a high frequency boost-up function that equalizes the
waveform of the read signal.
Cut-off frequency of the low-pass filter and boost-up gain are controlled from each DAC
circuit in read channel by an instruction of the serial data signal from MPU (M1). The MPU
optimizes the cut-off frequency and boost-up gain according to the transfer frequency of each
zone.
(3) Adaptive equalizer circuit
This circuit is 5-tap sampled analog transversal filter circuit that cosine-equalizes the head read
signal to the Extended Partial Response Class 4 (EPR4) waveform.
(4) Viterbi detection circuit
The sample hold waveform output from the adaptive equalizer circuit is sent to the Viterbi
detection circuit. The Viterbi detection circuit demodulates data according to the survivor
path sequence.
(5) Data separator circuit
The data separator circuit generates clocks in synchronization with the output of the adaptive
equalizer circuit. To write data, the VFO circuit generates clocks in synchronization with the
clock signals from a synthesizer.
(6) 16/17 GCR decoder
This circuit converts the 17-bits read data into the 16-bits NRZ data.