Programming, Driver controls – FORD 2006 Crown Victoria User Manual
Page 57
door to stop and reverse, does not meet current U.S. federal safety
standards. For more information, contact HomeLink
at:
www.homelink.com or 1–800–355–3515. Retain the original
transmitter for use in other vehicles as well as for future programming
procedures (i.e. new HomeLink
equipped vehicle purchase). It is also
suggested that upon the sale of the vehicle, the programmed HomeLink
buttons be erased for security purposes, refer to Programming in this
section.
Programming
Do not program the HomeLink
with the vehicle parked in the
garage.
Note: Some vehicles may require the ignition switch to be turned to the
second (or “ACC”) position for programming and/or operation of the
HomeLink
. It is also recommended that a new battery be placed in the
hand-held transmitter of the device being programmed to HomeLink
for
quicker training and accurate transmission of the radio-frequency signal.
1. Press and hold the two outside
buttons. The message CLEARING
CHANNELS will appear on the
HomeLink
display.
• After about 20 seconds, the
message CHANNELS CLEARED
will appear.
Do not repeat step one to program additional hand-held transmitters to
the remaining two HomeLink
buttons. This will erase previously
programmed hand-held transmitter signals into HomeLink
.
2006 Crown Victoria (cro)
Owners Guide (post-2002-fmt)
USA (fus)
Driver Controls
57