FRIGIDAIRE 318205121 - Manual (Page 9)

9
Care & Cleaning
(Cleaning Chart)
Surfaces
Aluminum (Trim Pieces)
& Vinyl
Painted and Plastic Parts,
Body Parts, and Decorative
Trim
Control Panel
Stainless Steel, Chrome,
Decorative Trim
Porcelain Enamel
Broiler Pan and Insert(some
models), Door Liner and Body
Parts.
Oven Racks
Oven Door
How to Clean
Use hot, soapy water and a cloth. Dry with a clean cloth. Do not scour or use all-purpose
cleaners, ammonia, powdered cleaners or commercial oven cleaner. They can scratch
and discolor aluminum.
For general cleaning, use hot, soapy water and a cloth. For more difficult soils and built-
up grease, apply a liquid detergent directly onto the soil. Leave on soil for 30 to 60
minutes. Rinse with a damp cloth and dry. DO NOT use abrasive cleaners on any of these
materials; they can scratch.
Before cleaning the control panel, turn all controls to OFF. Lightly spray the control
panel with a liquid cleaner. Wipe with a soft cloth or paper towel. DO NOT use
abrasive cleaners or scouring pads. These can permanently damage the control
panel.
Clean stainless steel with hot, soapy water and a dishcloth. Rinse with clean water
and a cloth. Do not use cleaners with high concentrations of chlorides or
chlorines. Do not use harsh scrubbing cleaners. Only use kitchen cleaners that are
especially made for cleaning stainless steel. Always be sure to rinse the cleaners
from the surface as bluish stains may occur during heating that cannot be removed.
Gentle scouring with a soapy scouring pad will remove most spots. Rinse with a 1:1
solution of clear water and ammonia.
If necessary, cover difficult spots with an
ammonia-soaked paper towel for 30 to 40 minutes. Rinse with clean water and a
damp cloth, and then scrub with a soap-filled scouring pad. Rinse and wipe dry with a
clean cloth. Remove all cleaners or the porcelain may become damaged during future
heating. DO NOT use spray oven cleaners.
Oven racks may be removed or left in the oven during the Self-Clean cycle for
cleaning. If removed, clean by using a mild, abrasive cleaner following manufacturer's
instructions. Rinse with clean water and dry.
If the racks are cleaned in the Self-Clean cycle, their color will turn slightly blue and
the finish will be dull. After the Self-Clean cycle is complete, and the oven has
cooled, rub the sides of the racks with wax paper or a cloth containing a small
amount of salad oil (this will make the racks glide easier into the rack positions).
Use soap & water to thoroughly clean the top, sides and front of the oven door. Rinse
well. You may use a glass cleaner on the outside glass of the oven door. DO NOT
immerse the door in water. DO NOT spray or allow water or the glass cleaner to
enter the door vents. DO NOT use oven cleaners, cleaning powders or any harsh
abrasive cleaning materials on the outside of the oven door. DO NOT clean the oven
door gasket
Self-Cleaning Models:
The oven door gasket is made of a woven material, which is essential for a good
seal. Care should be taken not to rub, damage or remove this gasket.