Meridian Audio Native Rate Series - Manual (Page 13)

APPENDIX B – IR SETUP COMMANDS
IR REMOTE TEACHING FUNCTIONS
Use the Function key to locate IR Setup Menu-Press Enter. Use the Value key to select the different
commands. Each time the Enter button is pressed it “flashes” the commands out through the IR receiver
window on the front panel. The Number of Samples choice defines how many time the NRS will send the
sample IR command. Adjust this if learning remote does not respond properly
IR COMMAND
1 POWER ON
0 POWER OFF
3 INPUT
4 ASPECT RATIO
5 BRIGHTNESS
6 CONTRAST
7 COLOR
8 TINT
9 DETAIL
10 NOISE REDUCTION
11 FUNCTION UP
12 FUNCTION DOWN
13 VALUE UP
IR SETUP COMMANDS
11
Direct Access Infrared Commands
To turn On the unit, a sequence must be used:
Press Power + #
1 = On, 0 = Off
Note: The timing of the digits (1&0) must be
under .25 seconds after the Power command is
issued.
Note: all sequence commands listed below
should have approximately a .25 second delay
between commands.
Input Control: Input + #
1 = Composite
2 = S-Video
3 = YPrPb (YCrCb)
4 = RGB
5 = Pass-through
Aspect Ratio Control: Aspect + #
1 = 4:3
2 = Letterbox
3 = Anamorphic
IR COMMAND
14 VALUE DOWN
15 PRESET / ENTER
16 MENU
17 0
18 1
19 2
20 3
21 4
22 5
23 6
24 7
25 8
26 9
Preset Select: Preset + #
1- 4, 0 = Factory
To change Levels, a sequence must be used:
Note: All the following commands must receive
a three digit number.
Brightness + ### (0-255)
Contrast + ### (0-155)
Color + ### (0-255)
Tint + ### (0-255)
Detail + 0## (0-31)
Noise Red. + 0## (0-15)
Note: The user can also adjust levels by using
the Value Up/Down keys or store the levels in
Presets and recall those when desired.