How to change the filters – Filtera 50100 User Manual

Page 7

Advertising
background image

CAUTION: DISCONNECT FROM POWER SUPPLY BEFORE SERVICING

Do not attempt to wash either the carbon pre-filter or the HEPA filter. They are
not washable and washing will damage the filters.

The only two parts requiring any service are the carbon pre-filter and the HEPA filter.

No tools are needed. To change either filter, disassemble the unit as shown below:

Step 1: Turn the air cleaner off and unplug from the wall outlet.

Step 2: To open, gently place the air cleaner on its side and unscrew the locking

mechanism located under the base assembly (Fig. 1).

Step 3: Remove the base assembly from the air cleaner.

Step 4: Remove the filter assembly (consisting of the HEPA filter and pre-filter) from the

internal chamber.

Step 5: Locate the seam of the pre-filter and carefully separate the fastener to remove

the pre-filter from the HEPA filter (Fig. 2).

Step 6: Discard used filter(s) being replaced. Remove any packaging and plastic

from the replacement filter(s).

Step 7: Carefully wrap the pre-filter around the HEPA filter so that the ends meet

(Fig. 3). Fasten the ends together with the fastener provided.

Step 8: Place the whole filter assembly into the internal chamber. Close the product

by replacing the base and tightening the locking mechanism.

Step 9

:

Turn the air cleaner into an upright position, plug into a wall outlet and it is

ready for operation.

How to Change the Filters

Advertising
This manual is related to the following products: