Cycle takes a long time, Dishwasher won’t fill, Dishwasher has an odor – FRIGIDAIRE 154881901 User Manual

Page 18: Stains on tub interior, Removing spots and film

Advertising
background image

18

SOLUTIONS TO COMMON DISHWASHING PROBLEMS

Dishwasher Does Not Drain

Properly

• If unit is hooked up to a food waste disposer, make

sure the disposer is empty.

• Check to see if the knockout plug has been removed

from inside the food waste disposer inlet.

• Check to see if drain hose is kinked.
• Make sure cycle is complete, not in a pause.

Cycle Takes a Long Time

• Is cycle in a water heating delay?
• Has the delay start option been selected?
• Has the sanitize option been selected? Selecting this

option will lengthen teh cycle.

Dishwasher Won’t Fill

• Is water supply turned on?
• Does overfill protector move up and down freely?

(See Overfill Protector section.)

Dishwasher Has an Odor

• Soiled dishes left in dishwasher too long can create

an odor. Use Rinse Only cycle.

• There will be a “new” smell when first installed. This

is normal.

• Check to see if unit is draining properly. (See

Dishwasher Does Not Drain Properly.)

Stains on Tub Interior

• Washing large amounts of dishware with tomato

based soil can cause a pink/orange appearance. This

will not affect performance and will gradually fade

over time. Pre-rinsing or using the Rinse Only cycle

will reduce the chance of staining. Using no heat dry
option will lessen staining.

Removing Spots and Film

Hard water can cause lime deposit buildup on the

interior of the dishwasher. Dishes and glasses may also

get spots and film for a number of reasons. (See

Glassware/Flatware Spotted or Cloudy section.) To

remove buildup, spots and film, clean using the following

instructions:
1. Load clean dishes and glasses in normal manner. Do

not load any metal utensils or silverware.

2. Do not add detergent.
3. Select the NORMAL WASH cycle. Close and latch

door. Press START/CANCEL pad.

4. Allow dishwasher to run until it starts the second

water fill (approximately 10 minutes).

5. Unlatch and open door and pour 2 cups of white

vinegar into the bottom of dishwasher.

6. Close and latch door and allow cycle to finish.

To customize your dishwasher to match your cabinets:

• You will need a trim kit.
• See Step 10 of Installation Instructions that came with your dishwasher for more information.

NOTE

If these conditions persist, a home water softener should

be considered.

Advertising