FRIGIDAIRE 3000 SpeedClean Series - Manual (Page 6)

6
Options Selections
Favorite Cycle
The FAVORITE CYCLE option allows you to
program your preferred cycle and options into one
button. Once programmed, simply press the
FAVORITE CYCLE button followed by the
START/CANCEL pad.
To program the FAVORITE CYCLE button:
1) Select your preferred cycle and options
2) Hold the FAVORITE CYCLE button for 3
seconds
The display will flash for 2 seconds indicating the
FAVORITE CYCLE option has been programmed.
To change the FAVORITE CYCLE option simple
repeat steps one and two above.
Turbo Boost
The TURBO BOOST option overrides the normal
cycle speed and adjusts to the maximum wash
speed. This option is recommended when there is
a heavy soiled load. TURBO BOOST can be
used with ULTIMATE SCRUB, NORMAL WASH,
and ECONO WASH cycles. TURBO BOOST
may be selected before the wash cycle is started
or anytime during the wash cycle.
Wash Silencer
The WASH SILENCER option overides normal
cycle speed and adjusts to the quietest cycle
speed. This option can be used with NORMAL
WASH, ECONO WASH, UPPER RACK, and
LOWER RACK cycles. WASH SILENCER can
be selected before the wash cycle is started, or
anytime during the wash cycle.
Hi-Temp Wash
When HI-TEMP WASH option is selected, the
dishwasher heats water in the main wash to
approximately 140°F (60°C).
This increase in water temperature helps
dishwasher detergent remove food grease and soil
from dishes more effectively and aids in drying. HI-
TEMP WASH option can be used with all cycles
except CHINA CRYSTAL (some models) and
RINSE ONLY. HI-TEMP WASH is automatically
provided when ULTIMATE SCRUB cycle is
selected.
Sanitize Option
To sanitize your dishes and glassware, select the
SANITIZE option. When selected, the light above
the pad will come on and remain on until end of
cycle. The water temperature in the final rinse will
be raised to 155°F (68°C) assuring bacteria is
destroyed. This option is available in Ultimate
Scrub, Normal and Econo cycles. Only these
sanitization cycles have been designed to meet
NSF requirements.
The cycle time will be extended until the proper
water temperature is reached. Washing action will
continue during the water heating delay. For best
results, the incoming water temperature should be
at least 120°F (49°C).
The sanitize criteria may not be satisfied if there is
an interruption of the cycle, power failure or if the
incoming water temperature is below 120°F
(49°C).
To turn off the SANITIZE option, press the pad a
second time. The light above the pad will turn off.
Operating Instructions
(continued)
Heat Dry
The HEAT DRY option in combination with rinse
aid will enhance drying performance. The energy
required to use the HEAT DRY option costs
pennies per cycle. You may choose not to select
the HEAT DRY option; however you will have items
in your dish load that will not be completely dry at
the end of the cycle.
You may see water vapor coming from the vent
during the drying portion of cycle. The vent is
closed during washing to hold moisture and sound
inside. The vent opens during the last few minutes
of the final rinse and remains open for drying. The
drying option may be changed at any time during
the cycle and affects only the drying period.
Opening the door longer than one minute during
the dry cycle cancels the selected dry program.
When an option is selected, the light above the
pad will come on and remain on until end of cycle.
To turn off the option, press the pad a second time.
The light above the pad will turn off.