Fisher-Price JEEP B1501 - Manual (Page 13)

Bushing
(Ring Side First)
• Turn the vehicle assembly upright.
• Fit the two tabs on the front of the seat into the two
slots in the vehicle body.
13
13
Assembly
• Insert a #10 x 1" screw through the back of the seat
and into the vehicle body.
• Tighten the screw with a Phillips screwdriver.
Do not over-tighten.
• Position the roll bar so that it bends toward the back
end of the vehicle.
• Insert and "snap" the roll bar into the large holes in the
top side of the vehicle body, as shown.
• Pull up on the roll bar to be sure it is secure.
14
15
• Turn the vehicle assembly upside down on a flat surface.
• Fit a washer, bushing (ring side first), wheel
(indented side first) and hubcap (pointed side first)
onto one of the front axles.
• Fit a .437 cap nut onto the end of the front axle.
• Tap the cap nut with a hammer to secure the cap nut on
the front axle. Pull on the cap nut to be sure it is secure.
• Repeat this procedure to assemble the other washer,
bushing, wheel, hubcap and cap nut to the other
front axle.
12
Wheel
(Indented Side First)
Hubcap
(Pointed Side First)
.437
Cap Nut
Seat
Seat Tabs
Slots
Large
Hole
Large
Hole
Roll Bar
Washer
Front Axle
Bushing
Ring
Side .437"