Adjusting your oven temperature, Care & cleaning – FRIGIDAIRE ES510 User Manual
Page 35
35
Note: The oven
temperature adjustments
made with this feature will
not change the Self-Clean
cycle temperature.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
The temperature in the oven has been pre-set at the factory. When first using the oven, be
sure to follow recipe times and temperatures. If you think the oven is too hot or too cool, the
temperature in the oven can be adjusted. Before adjusting, test a recipe by using a
temperature setting that is higher or lower than the recommended temperature. The baking
results should help you to decide how much of an adjustment is needed.
To adjust the oven temperature higher:
1.
Press
for 6 seconds (Fig. 1).
2.
To increase the temperature use the number pads to enter the
desired change. (Example 30°F)
(Fig. 2). The
temperature may be increased as much as 35°F (19°C).
3.
Press
to accept the temperature change and the display
will return to the time of day (Fig. 3). Press
to reject the
change if necessary.
To adjust the oven temperature lower:
1.
Press
for 6 seconds (Fig. 4).
2.
To decrease the temperature use the number pads to enter the
desired change. (Example -30°F)
and then press
(Fig. 5). The temperature may be decreased as much as
35°F (19°C).
3.
Press
to accept the temperature change and the display
will return to the time of day (Fig. 6). Press
to reject the
change if necessary.
INSTRUCTIONS
PRESS
DISPLAY
Adjusting Your Oven Temperature
The oven light bulb is located at the rear of the oven and is covered with a glass shield held by
a wire holder. The glass shield must be in place whenever the oven is in use.
To replace the oven light bulb:
1.
Turn electrical power off at the main source or unplug the range.
2.
Press wire holder to one side to release the glass shield.
3.
Replace bulb with a new 40 watt appliance bulb.
4.
Replace glass shield over bulb and snap wire holder into place.
5.
Turn power back on again at the main source (or plug the range back in).
6.
The clock will then need to be reset. To reset, see Setting the Clock and Minute Timer.
Be sure the range is unplugged and all parts are COOL before replacing oven
light. Wear a leather-faced glove for protection against possible broken glass.
Changing the Oven Light
Care & Cleaning