FRIGIDAIRE 316135914 - Manual (Page 23)

23
Meat too close to the broil burner. Reposition the rack to provide more clearance
between the meat and the broiler.
Meat not properly prepared. Remove excess fat from meat. Slash remaining fatty edges
to prevent curling, but do not cut into the lean.
Broiler pan used without grid or grid covered with foil. DO NOT use the broiler pan
without the grid or cover the grid with foil.
Broiler drawer needs to be cleaned. Excessive smoking is caused by a build up of grease
or food spatters. If the broiler is used often, clean on a regular basis.
Broiler drawer is open. Drawer/door should be closed when broiling.
This oven is equipped with a state of the art electronic oven controller. Among its many
features is a full time oven circuit diagnostics system. The controller constantly
monitors its internal circuitry as well as several crucial oven circuits to insure they are
all operating correctly. If at any time one of these systems fails, the controller will
immediately stop operation, and beep continuously (flashing an error code of F1 or F3*
in the display window, if equipped).
Electronic control has detected a fault condition. Push CLEAR to clear the display and
stop beeping. Reprogram oven. If fault recurs, record fault number. Push CLEAR and
contact an authorized servicer.
Many factors affect baking results. Make sure the proper rack position is used. Center
food in the oven and space pans to allow air to circulate. Allow the oven to preheat to
the set temperature before placing food in the oven. Try adjusting the recipe's
recommended temperature or baking time. If you feel the oven is too hot or cool, see
Customizing Your Oven Performance in this Owner's Guide.
Controls are not set properly. Follow instructions under Oven Cleaning.
Self-cleaning cycle was interrupted. Stop time must be set 2 to 4 hours past the start
time. Follow steps under "Stopping or Interrupting a Self-Clean Cycle" under Oven
Cleaning.
Failure to clean bottom front, top of oven or door areas outside oven seal. These areas
are not in the self-cleaning area, but get hot enough to burn on residue. Clean these
areas before starting the self-clean cycle. Burned-on residue may be cleaned with a stiff
nylon brush and water or a nylon scrubber. Be careful not to damage the oven gasket.
Excessive spillovers in oven. Set self-clean cycle for a longer cleaning time.
Excessive spillovers in oven. This is normal, especially for pie spillovers or large amounts
of grease on the oven bottom. Wipe up excessive spillovers before starting the self-
clean cycle. If flames or excessive smoke are present, stop the self-clean cycle and follow
the steps under "Stopping or Interrupting the Self-Clean Cycle" in the Oven Cleaning
section.
Oven smokes excessively during broiling.
Oven Control Errors
*Oven control beeps and displays F1 or F3.
Poor baking results.
Self-Cleaning cycle does not work.
Soil is not completely removed.
Flames inside oven or smoking from vent.