FRIGIDAIRE 600 Series - Manual (Page 4)

4
Operating Instructions
Vent Latch
Delay Start
Allows you to delay starting the POTS & PANS
cycle up to 6 hours.
• Turn dial to select number of hours.
• Select HI-TEMP WASH ON option and other
desired options.
• Close door to latch. The DELAY START light
will come on.
Getting Started
1. Load dishwasher (See Preparing and
Loading Dishes).
2. Add detergent (See Dishwasher Dispenser
& Detergents).
3. Add rinse aid, if needed (See Rinse Aid).
Wash Cycle Selections
Note: Cycle times are approximate and will
vary with options selected. Hot water is
necessary to activate dishwasher detergent
and melt fatty food soils. An automatic sensor
will check the incoming water temperature
and, if it is not hot enough, the timer will be
delayed for automatic water heating in the
main wash of all cycles. This happens even
though HI-TEMP WASH ON option has not
been selected. When HI-TEMP WASH ON is
selected, an even higher temperature will be
guaranteed to handle heavier soil loads.
Very Important
Information— Read Before
Operating Your Dishwasher!
Normal Operating
Sounds
This dishwasher does not sound like most
dishwashers—IT’S QUIETER.
The new Precision Wash System™ uses
energy efficient motors for the wash and
drain portions of the cycle you select. Each
cycle has a series of water fills and drains for
washing and rinsing dishes. As each cycle
begins, you may–or may not–hear the drain
motor.
The next sound you will hear is the
splashing water as it enters the tub. Then
the lower arm rotates and circulates water.
This is followed by a pause and a slightly
different sound as the middle arm sprays
water. If you listen closely, you will hear the
change in sound as the wash action switches
from one arm to the other.
PLEASE BE ADVISED: If you compare this
dishwasher to previous models, you may
be surprised at what you DON’T hear!
4. Turn dial clockwise to select cycle (See Cycle
Chart) or number of hours for delay start.
5. Select desired energy OPTIONS (See Energy
Options). The indicator will show red
when selected.
6. For instructions on connecting the portable
dishwasher, see “Connecting and
Disconnecting the Portable/Convertible
Dishwasher.”
7. If using DELAY START, go to step number 9.
8. Run hot water faucet nearest dishwasher
until water is hot. Turn water off.
9. To start, close door to latch.