FMI FVFM27PR - Manual (Page 13)

13 105224
OWNER’S MANUAL
O
F F P IL OT O N
H I L O
INSTALLATION
Continued
WARNING: Failure to posi-
tion the parts in accordance with
these diagrams or failure to use
only parts specifically approved
with this heater may result in prop-
erty damage or personal injury.
INSTALLING LOGS
It is very important to install the logs exactly
as instructed. Do not modify logs. Only use
logs supplied with heater.
1. Place bottom log (#1) on grate to fit as
illustrated in Figure 17. Make sure open
areas of log set line up with burner ports
(see Figure 18). Log will fit securely on
chassis.
IMPORTANT: Make sure log
does not cover any burner ports.
2. Facing front of unit, place top log (#2)
onto the pegs in the center of the bot-
tom log (see Figure 19).
3. Position log piece (#3) by aligning
holes on underside with remaining pegs
on bottom log (see Figure 20).
4. Place lava rock on fireplace floor
around base of heater.
Figure 17 - Installing Bottom Log (#1)
Figure 18 - Installing Log set (Top View)
Logs Burner
Ports
Bottom Log (#1)
Burner
Chassis
CAUTION: After installation
and periodically thereafter, check
to ensure that no flame comes in
contact with any log. With the
heater set to High, check to see if
flames contact any log. If so, re-
position logs according to the
log installation instructions in this
manual. Flames contacting logs
will create soot.
O
F F P IL OT O N
H I L O
O
F F P IL OT O N
H I L O
Figure 19 - Installing Top Log (#2)
Figure 20 - Installing Log Piece (#3)
Grate
Burner
Port
Top Log
(#2)
Peg
Log Piece (#3)
Peg