Firstech, LLC. COMPUSTAR CM3000 - Manual (Page 4)

Firstech, LLC. Technical Data (CM3000)
4
Connector #3:
Pin #1: Light Blue- This needs to be connected to the parking brake.
This wire requires a (-) input to activate. This wire serves two functions:
1. To engage Reservation Mode for manual transmissions, reference
the users or install guide.
2. To activate the Turbo Timer, reference the users or install guide.
Pin #2: Gray/Black- This is the (-) shutdown for the Hood Trigger.
This wire serves two functions:
1. It prevents the remote start from activating while the hood is open
2. It will trigger a full alarm if the hood is opened when the alarm has
been armed.
Pin #3: Light Blue/White- This is the (+) shutdown for the foot brake.
This wire will shut down the remote start if the foot brake is pressed.
Pin #4: Violet/Black- This wire is the (-) trigger input, which needs to
be connected to a trunk pin or trunk trigger. This will trigger a full
alarm if the trunk is opened while the alarm is armed.
Pin #5: Red/White- This wire is the (-) trigger input for the door
trigger. You would connect this to the trigger that shows (-) when the
door is opened.
Pin #6: Red- This wire is the (+) input for the door trigger. You would
connect this to the trigger that shows (+) when the door is opened.
Pin #7: Brown/Black- This is the trigger input for a (-) glow plug wire.
Pin #8: Brown/White- This is the trigger input for a (+) glow plug wire.
Pin #9: Yellow/Black- this wire serves as the Tachometer input or the
Alternator input. Either way you use it, it is for engine sensing. This
wire tells the CompuStar when to quit cranking the starter of the vehicle.
There are a couple of ways to find the correct voltage for either type of
sensing. Please review the following tips on the next page.