FRIGIDAIRE 316901213 - Manual (Page 16)

16
Your appliance has been factory calibrated and tested to
ensure an accurate baking temperature. For the first few
uses, follow your recipe times and temperature
recommendations carefully. If you think the oven is cooking
too hot or too cool for your recipe times, you can adjust the
control so the oven cooks hotter or cooler than the
temperature displayed.
To adjust oven temperature:
1. Press bake.
2. Set the temperature to 550°F (287°C) by pressing and
holding the .
3. Within 2 seconds, press and hold bake until numeric
digit(s) appear. Release bake keypad. The display now
indicates the amount of degrees offset between the
original factory temperature setting and the current
temperature setting. If the oven control has the original
factory calibration, the display will read "0."
4. The temperature can now be adjusted up or down 35°F
(19°C), in 5°F increments by pressing and holding the
or . Adjust until the desired amount of offset
appears in the display. When lowering the oven
temperature, a minus sign (-) will appear before the
number to indicate that the oven will be cooler by the
displayed amount of degrees.
5. When you have made the desired adjustment, press
clear off to go back to the time of day display.
Adjusting the oven temperature
Oven temperature adjustments made will not affect the
broil or self-cleaning feature temperatures.
If the display is set for Celsius, adjustments made will be in
1°C increments each press of the or keys.
DO NOT USE oven thermometers such as those found in
grocery stores to check the temperature settings inside your
oven. These oven thermometers may vary as much as 20 to
40 degrees from actual temperatures.
NOTES
To set the oven lockout feature
1. Press clear off and hold for 3 seconds. “Loc” will
appear in display, the “Door Locked” indicator light will
flash and the motor driven door lock will begin to close
automatically. Allow about 15 seconds for the oven
door to lock. Once the oven door is locked, the current
time of day will appear in the display.
2. To cancel the Oven Lockout feature, press clear off
and hold for 3 seconds. The control will unlock the oven
door and resume normal operation.
DO NOT open the oven door while the indicator light
is flashing. Allow about 15 seconds for the oven door to
lock. Once the oven door is locked, the current time of
day will appear in the display.
If any control pad is pressed with the oven lockout
feature active, “Loc” will appear in the display until the
control pad is released.
NOTES
Setting oven lockout
The control can be programmed to lock the oven door and
lockout the oven control pads.
Operating oven light (some models)
The interior oven light will automatically turn ON when the
oven door is opened. Press the oven light switch located on
the upper left control panel to turn the interior oven light ON
and OFF whenever the oven door is closed.
The interior oven light is located at the upper left rear wall
of the oven interior and is covered with a glass shield held
by a wire holder. The glass shield must be in place
whenever the oven is in use. To change the interior oven
light, see "Changing the oven light" in the Care & Cleaning
section.
SETTING OVEN CONTROLS
oven light switch