Grizzly G0640X - Manual (Page 13)

G0640X 17" Wood/Metal Bandsaw
-11-
After all parts have been removed from the three
boxes, you should have the following items:
Main Components: (Figure 2 & 3) Qty
A. Bandsaw (not shown) ................................. 1
B. Table .......................................................... 1
C. Miter Gauge ................................................ 1
D. Fence Assembly ......................................... 1
E. Resaw Fence Attachment .......................... 1
F. Front Fence Rail ......................................... 1
G. Rear Fence Rail ......................................... 1
H. Handwheel (not shown) ............................. 1
I. V-Belt A27 (not shown) .............................. 1
J. Scale (not shown) ...................................... 1
Fasteners (and where used): Qty
Hex Bolt M8-1.25 x 100 (Positive Stop) ............ 1
Hex Nut M8-1.25 (Positive Stop) ....................... 1
Cap Screw M6-1 x 20 (Handwheel) .................. 1
Hex Bolts M8-1.25 x 16 (Table) ........................ 4
Lock Washers 8mm (Table) .............................. 4
Flat Washers 8mm (Table) ................................ 4
Cap Screws M6-1 x 25 (Rear Rail) ................... 2
Hex Bolts M6-1 x 20 (Front Rail) ....................... 2
Lock Washers 6mm (Front Rail) ....................... 2
Flat Washers 6mm (Front Rail) ......................... 2
Hex Nut M8-1.25 (Fence Lock Lever) ............... 1
Hex Nut M6-1 (Rail Pad) ................................... 1
Flat Washer 8mm (Attachment Lock Handle) ... 1
Tools & Other Miscellaneous Items: Qty
Hex Wrench 5mm .............................................. 1
Hex Wrench 8mm .............................................. 1
Open End Wrench 10/13mm ............................. 1
Table Pin ........................................................... 1
Table Insert ....................................................... 1
Rail Pad M6-1 x 18 (attaches to fence) ............ 1
Fence Lock Lever M8-1.25 x 22 ....................... 1
Fence Attachment Lock Handle M8-1.25 x 44 .. 1
Fence Attachment T-Slot Nut ............................ 1
Figure 2. Bandsaw components.
B
C
D
Figure 3. Fence components.
G
E
D
F
If any nonproprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them, or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
Some hardware/fasteners on the inventory
list may arrive pre-installed on the machine.
Check these locations before assuming that
any items from the inventory list are miss-
ing.
Inventory