Grizzly G1183 - Manual (Page 13)

G1183/1276 Combination Sander -11-
Disc Table
The disc table adjusts to allow you to sand your
work at angles from -20° up to 45°. To install the
disc table:
1. Loosen the two star knobs at either end of
the disc table base until they reach the
ends of their threaded rods.
2. Move the sliding rails and the washers to
allow enough room for the table to be
installed.
3. Flip the 90° stop block out of position.
4. Install table securely between the two slid-
ing rails as shown in
Figure 6 .
5. Tighten star knobs to secure the table in
position.
Figure 6. Attaching disc table.
Belt Lever
The belt lever is used for releasing the tension on
the idler pulley for belt installation. To attach the
belt lever:
1. Thread the belt lever onto the loosen/tighten
collar and secure with the checknut.
See
Figure 7 .
Figure 7. Attaching belt lever.
Belt Lever
Loosen/Tighten Collar
DO NOT attempt to operate this machine
before completing the assembly and adjust-
ment instructions. Be sure that the switch is
off and the cord is disconnected from the
power source at all times until assembly
and adjustment are complete and you have
reviewed all safety guidelines. Serious
injury could occur.
NOTICE
After all parts have been assembled, dou-
ble-check the entire machine to make sure
all fasteners are tight.