GE 24962 - Manual (Page 8)

8
Code Search
If your device does not respond after you have
tried all the codes for your brand, or if your brand is
not listed, try searching for your code by following
these steps.
1. Manually turn on the device ( TV, DVD, etc.) to
be controlled.
2. Press and hold the SETUP button until
the red indicator stays on, then release
the SETUP button.
3. Press and quickly release the desired
mode button ( TV, DVD, etc.). The red
indicator blinks off once.
4. Press the CHAN+ button
repeatedly (up to 300 times)
until the device to be controlled
changes channel. The red
indicator blinks off with each
button press. If you accidentally overshoot
the code required, press the CHAN- button to
backtrack through the library until the device
changes channel. Pressing CHAN+ changes
direction to forward again.
5. Press and release ENTER to install the
code.
Most users will store DVD codes under the DVD button,
and Satellite or Cable codes under SAT/CBL. If (for ex-
ample) you want to store a DVR code under SAT/CBL,
first follow the procedure for Direct Code Entry (page
8) and press SAT/CBL in step 2 of Direct Code Entry,
then enter ANY DVR code in step 3 of Direct Code Entry.
Then follow the steps above for Code Search.
Note: If the device does not have a CHAN+ button, use
PLAY (DVD/DVR/VCR only) or POWER instead. Code
Search starts from the currently stored 4 digit number
under that mode. Sometimes the first code that “works”
with your device may only allow limited functionality
(e.g., the MENU button might not work). There may be
a code that performs more functions. Continue the code
search process until the best code is found.