Grizzly Heirloom Strarocaster-Style Kit BL8551 - Manual (Page 9)

H8069 Heirloom Stratocaster-Style Guitar Kit
-7-
SECTION 4: ASSEMBLY
Peghole Placement
Figure 6. Marking string paths.
3. Make a mark 1 13 ⁄
16
" from the fretboard side of
the nut slot on line "A" shown in Figure 7.
Figure 7. Peghole placement, first mark.
4. Place the machinist square against the angled
edge of the headstock and draw a light pencil
line through the mark made in
Step 3.
5. Make a mark on the line made in Step 4, 1 ⁄
4
"
towards the headstock edge from the line
made in
Step 2 as shown in Figure 8. This
marks the center of the first peghole. This
mark should be parallel to and
1 /
2
" from the
angled edge of the headstock.
The headstock is rough machined to fit all six
tuners on one side. These instructions will guide
you through the placement of the pegholes. The
pegholes must be drilled slightly undersized so
that the bushings will be tight. Correct placement
of the pegholes will make the tuner installation
easier.
We recommend you read through the assembly
section to gain an overview of the process before
beginning.
Components Needed Qty
Guitar Neck ....................................................... 1
To drill the pegholes in the headstock:
1. Center the nut in the nut slot and mark the
string slots on the fretboard with a pencil.
Make sure the larger grooves of the nut are
toward the top of the neck.
2. Remove the nut and align the leading edge
a machinist's square with either edge of the
nut slot. Use a pencil to extend the string
slot marks onto the headstock as shown in
Figure 6.
� � ��
� � ��
Figure 8. Peghole placement and second mark.
Leading Edge
Nut Slot
Nut Slot
First Mark
Angled Edge of
Headstock
1 13 ⁄
16
A
Second
Mark