Control settings – GE EDW3000 User Manual

Page 5

Advertising
background image

Consumer Support

Tr

oubleshooting T

ips

Operating Instructions

Safety Instructions

The Status

The Status display tells you what is happening while the dishwasher is in operation and also any malfunctions if they occur (see page 6).
The lights will come ON indicating the sequence of operation the dishwasher is in.

SENSING Displayed during periods using CleanSensor technology to measure the amount of soil in the load and decide if another prewash is needed.

The SENSING light is displayed only during NORMAL and POTS & PANS cycles.

WASHING Displayed during prewash and main wash periods.

RINSING Displayed during rinse periods.

DRYING Displayed during SPEED DRYING/HEATED DRYING.

SANITIZED Displayed when cycle has met sanitization conditions. Light remains ON until door is opened.

Load Selections

The light above the selected pad will be ON to indicate which LOAD SELECTION has been selected.

SANI WASH This cycle raises the water temperature in the final rinse to sanitize your dishware. The cycle length will vary depending on the temperature

of your inlet water.

NOTE: The SaniWash cycle is monitored for sanitization requirements. If the cycle is interrupted during or after the main wash portion or
if the incoming water temperature is so low that adequate water heating cannot be achieved, the sanitizing conditions will not be met.
In these cases, the sanitized light will not illuminate at the end of the cycle.

NOTE: Only the SaniWash cycle has been designated to meet the requirements of NSF184 for soil removal and sanitization efficiency.
Certified residential dishwashers are not intended for licensed food establishments.

POTS & PANS For heavily soiled dishes or cookware with dried-on or baked-on soils. Everyday dishes may be included. This cycle will not remove

burned-on foods.

NORMAL For loads of everyday dishes, glasses and cookware with medium soils. NOTE: Many dishes have lighter soil than normal. Choosing a

cycle other than NORMAL will save energy and water.

SPEED WASH/ For dishes with light soils.

LIGHT WASH

CHINA CRYSTAL For lightly soiled china and crystal.

RINSE ONLY For rinsing partial loads that will be washed later. Do not use detergent.

Options

The light above the selected pad will be ON to indicate which OPTION has been selected.

POWER For use with heavily soiled and/or dried-on, baked-on soils. This option MUST be selected PRIOR to starting the cycle.

PRESOAK This option adds 16 minutes to the cycle time.

SPEED DRY/ Shuts off the drying heat option. Dishes air dry naturally and energy is saved. You can prop the door open after the CLEAN light

HEATED DRY illuminates.

OFF

SPEED DRY/ Turns the heater on for fast drying. This cycle will extend the time to your wash cycle by 23 minutes for the NORMAL cycle and

HEATED DRY 30 minutes for the SANI WASH

Advertising