About the shelves and bins – GE 200D8074P044 User Manual

Page 8

Advertising
background image

8

Consumer Support

Troubleshooting Tips

Operating Instructions

Safety Instructions

Installation Instructions

About the shelves and bins.

Not all features are on all models.

QuickSpace

Shelf

(on some models)

This shelf splits in half and slides under itself for

storage of tall items on the shelf below.
This shelf can be removed and replaced

or relocated just like Slide-Out Spillproof

Shelves.

On some models, this shelf can not be used in

the lowest position.

Slide-Out Freezer Shelves

To remove,

slide out to the stop position,

lift the front past the stop position, and slide out

from rib.

Make sure you push the shelves all the way back
in before you close the door.

Freezer Baskets

(on some models)

To remove

, slide out to the stop position,

lift the front past the stop position, and

slide out.

Make sure you push the baskets all the way back
in before you close the door.

Fixed Freezer Shelves

To remove,

lift the shelf up at the left side and

then bring the shelf out.

NOTE FOR DISPENSER MODELS:

In order

to take full advantage of the tilt-out ice bin (on

some models), only store items on the shelf

below the ice bin that are no taller than the

lowest point on the bin.

Freezer Baskets

(on some models)

To remove,

push the basket all the way to the

back of the freezer. Lift up until the back pins

are disengaged. Lift the entire basket up and

pull out.

Make sure you push the baskets all the way back
in before you close the door.

Door Wine/Beverage Rack

(on some models)

This rack holds up to 5 cans, one bottle

of wine or one 2-liter bottle of soda.
The rack hangs from the sides of the

dairy bin.
To remove:

Empty the wine/beverage rack.

Holding the bottom of the dairy bin,

lift the front straight up, then lift up and

out.
To detach the rack from the dairy bin, pull

the rack’s side wires out of the holes on

each side of the dairy bin.

To replace:

Reattach the rack to the sides

of the bin.
Engage the back side of the bin in

the molded supports on the door.

Then push down on the front of the bin.

The bin will lock into place.

Advertising