Grizzly G9961 - Manual (Page 24)

-22- Extreme Duty Planers
This section is designed to help the operator with
adjustments that were made at the factory and
that might also need to be made during the life of
the machine.
This section is provided for your convenience—
it is not a substitute for the Grizzly Service
Department. If any adjustments arise that are not
described in this manual, then feel free to call the
Grizzly Service Department at (570) 546-9663.
Similarly, if you are unsure of how to perform
any procedure in this section, the Grizzly Service
Department will be happy to guide you through
the procedures or help in any other way.
Always disconnect
power to the machine
before performing ser-
vice adjustments. Failure
to do this may result in
serious personal injury.
Adjustment Controls
Figures 5 and 6 point out the primary controls
and components that will be used during the
adjustment process. Take a few minutes to famil-
iarize yourself with these.
Figure 5. Planer controls.
Figure 6. Planer components.
Table
Cutterhead
Chip Breaker
Rear Feed
Roller
Front Feed
Roller
Anti-Kickback
Claw
Pressure
Bar
Bed
Rollers
Bed Roller
Height Lever
Micro-Adjust
Height Knob
Cutterhead Lock
Table Height
Lock
Height Controls
Planer knives are danger-
ously sharp! Use extreme
caution when working
near cutting surfaces.
Failure to exercise care
while working near knives
could result in severe
injury.
About Service
SECTION 9: SERVICE ADJUSTMENTS