GE 45609 - Manual (Page 12)

12
FCC
U2Z45609
The Federal Communication Commission Radio Frequency Inter-
ference Statement includes the following paragraph:
The equipment has been tested and found to comply with the
limits for a Class B Digital Device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment uses, generates and can radiate radio frequency
energy and, if not installed and used in accordance with the
instruction, may cause harmful interference to radio communi-
cation. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
Operation is subject to the following two conditions:
• This device may not cause interference
• This device must accept any interference, including
interference that may cause undesired operation of the device.
Important Note: To comply with the FCC RF exposure compliance
requirements, no change to the antenna or the device is permit-
ted. Any change to the antenna or the device could result in the
device exceeding the RF exposure requirements and void user’s
authority to operate the device.
Compliance with IC Rules and Regulations
IC: 6924A-45609
Jasco Products Company
Model: 45609
This Class B digital device complies with Canadian ICES-003.