Rough-in dimensions, Location of your washer, Installation instructions – GE WBVH5300 User Manual

Page 16: Do not install the washer, Minimum installation clearances

Advertising
background image

16

Installation Instructions

LOCatIOn OF yOUr WaSHEr

Do not Install the Washer:

1. In an area exposed to dripping water or outside

weather conditions. The ambient temperature should

never be below 60°F (15.6°C) for proper washer

operation.

2. In an area where it will come in contact with curtains

or drapes.

3. On carpet. The floor MUSt be a hard surface with

a maximum slope of 1/2″ per foot (1.27 cm per

30 cm). To make sure the washer does not vibrate

or move, you may have to reinforce the floor.

nOtE: If floor is in poor condition, use 3/4″ impregnated

plywood sheet solidly attached to the existing floor

covering.
IMPOrtant:

Minimum Installation Clearances

When installed in alcove: Sides, Rear,

Top = 0″ (0 cm)

When installed in closet: Sides, Rear,

Top = 0″ (0 cm), Front = 1″ (2.54 cm)

Closet door ventilation openings required:

2 louvers each 60 square in. (387 cm

2

), located 3″

(7.6 cm) from top and bottom of door

rOUgH-In DIMEnSIOnS

SIDE

FRONT

27.0”

(68.6 cm)

20.4” (51.9 cm)

ELECTRONIC TRANSPARENT VISOR

2.2”

(5.6 cm)

40.6”*

(103.1 cm)

30.6”

(77.7 cm)

1.6”

(3.9 cm)

40.6”*

(103.1cm)

39.1”

(99.2 cm)

*NOTE: With pedestal, 52.6”

Stacked, 84”

Advertising
This manual is related to the following products: