Grizzly G1060 - Manual (Page 13)

G1060 22'' Scroll Saw -11-
Safety Shield
Always wear safety glasses. The Safety Shield
included with your Scroll Saw should be used as
additional protection for your face and eyes
should the blade snap or material be ejected from
the blade area toward your head. To adjust the
safety shields:
1. Loosen the Wing Nut on the Support Clip.
Figure 8.
2. Swivel Shield into desired position.
3. Tighten Wing Nut.
4. Once you are sure the Table is at 90˚, tighten
the Tilt Adjustment Knob. It will also be nec-
essary to loosen the pointer and reset it.
Now that the table is perpendicular to the blade,
any angle you set between 0 and 30˚ will be
accurate. To do this:
1. Facing the Saw, turn the Table Insert 90˚ to
the right as shown in
Figure 7.
Figure 7.
Figure 8.
2. Under the Table and to the left, locate the Tilt
Adjustment Knob. Turn the knob counter-
clockwise and lift the right edge of the table.
When the table reaches the desired angle,
tighten the Tilt Adjustment Knob.