Grizzly Pneumatic Jitterbug H0594 - Manual (Page 2)

Operation
To operate the sander:
1. Plug the tool into compressed air.
2. Hold the sander and press the throttle lever
( Figure 4) to operate.
Figure 5. Lubricating directly into air fitting.
3. Turn the regulator knob (Figure 4) to adjust
the sanding speed.
4. Remove pressure on the throttle lever to stop
the sander.
5. When the sandpaper loses its effectiveness,
disconnect the sander, remove sandpaper
from the clamps, and replace with a new
sheet.
Figure 4. Sander controls.
Maintenance
Lubricate at the beginning of the sanding task.
Place one or two drops of pneumatic tool oil
directly into the air fitting as shown in
Figure 5.
Regulator
Knob
A filter/lubricator/regulator setup is not recom-
mended, as excess oil in the tool could spray onto
the workpiece.
Run the sander for a few minutes to eject excess
oil, then wipe the tool down with a rag and begin
sanding. Oil the tool after use or storage.
If you need help with your new pneumatic tool,
call our Tech Support at: (570) 546-9663.
Throttle
Lever