Grizzly POWER FEED H8370 - Manual (Page 4)

-4-
H8370.(Mfg..Since.7/11)
Electrocution or fire could
result if machine is not
grounded and installed in
compliance with electrical
codes. Compliance MUST
be verified by a qualified
electrician!
10.. Remove.the.backing.from.the.adhesive.tape.
on.the.gear.safety.cover.flanges,.then.mount.
the. cover. on. the. assembly,. as. shown. in.
Figure 9.
Figure 9..installing.the.gear.safety.cover.
Gear
Safety
Cover
11.. Slide. the. T-nuts. of. the. limit. stops. into. the.
front.slot.of.the.table,.and.position.them.near.
the. ends. of. the. slots,. then. tighten. the. cap.
screws.to.secure.them.in.place.
12.. install.the.bracket.and.limit.switch.in.the.cen-
ter.of.the.saddle,.as.shown.in. Figure 10,.so.
that. the. plungers. on. the. sides. of. the. switch.
align.with.the.limit.stops.
Figure 10..installing.the.bracket.and.limit.switch.
limit
Switch
Bracket
13.. Make.sure.the.on/oFF.switch.is.in.the.OFF.
position,.then.connect.the.power.feed.unit.to.
a.grounded.110V.power.source.
Maintenance
Clean.and.lubricate.the.power.feed.gearing.every.
three.months.of.normal.use.
1.. DiSConneCT. THe. Mill/DRill. AnD.
PoWeR.FeeD.FRoM.PoWeR!
2.. Remove.the.gear.safety.cover.
3.. Remove. the. power. feed. assembly. from. the.
table.bracket.
4.. Clean. the. debris. and. built-up. grime. from.
the.drive.gear,.leadscrew.gear,.and.the.sur-
rounding.area.
5.. Brush.a.light.coat.of.all-purpose.grease.onto.
the.teeth.of.the.drive.and.leadscrew.gears.
6.. Re-install. the. parts. removed. in. reverse.
order.